KTO 011: Thermostat (normally closed); contact breaker for regulating heaters. KTS 011: Thermostat (normally open); contact maker for regulating of filter fans and heat exchangers or for switching signal devised when temperature limit has been exceeded.
FKO 011:The rmostat(normally closed),contact breaker for regulating heaters. FKS 011:Thermostat(normally open),contact maker for regulating of filter fansand heat exchangers or for switching signal devised when temperature limit hasbeen exceeded.
Tamperproof (Pre-set) Thermostat - NC, Opens on temperature rise (red module housing) - for regulating heaters or for switching signal devices when temperature has fallen below the minimum value.
The airflow monitor (NC/NO) is designed to indicate the loss of air movement of a fan or filter fan. The contact detects the loss of air movement caused by fan failure or blocked filter media regardless of direction of air.
It has become more and more important to provide a protected enclosure environment for valuable and crucial electrical and electronic components. In a tightly closed enclosure. pressure differentials can occur during extreme temperatu re variations. such as day/night operation.
Pressure differentials in enclosures with a high degree of protection are a result of internal and external temperature changes. In the case of negative pressure or partical vacuum, dust and humidity can enter the enclosure through the door seal.
Pressure differentials in enclosures with a high degree of protection are a result of internal and external temperature changes. In the case of negative pressure or partical vacuum, dust and humidity can enter the enclosure through the door seal.
Electronic thermostat for regulating high performance DC 24V equipment. Heatingor cooling appliances as well as signal devices can be switched via the potential freechange-over contact. In comparison to mechanical thermostats. the ET 011 has alow hysteresis making the switching point and setting accu racy more precise.
The electronic hygrotherm senses the ambient temperature and relative humidity in anenclosure with electric/electronic component, and turns on a heater(or alternatively, a fan) ateither set point. helping prevent the formation of condensation in the enclosure.
STEGOFIX is an appliance holder for direct fixing of small appliances and perforated 35mm DIN rails. With STEGOFIX small appliances can be mounted in switch cabinets significantly quicker, easier and more economically than before, without drilling holes.